SA56004X
All information provided in this document is subject to legal disclaimers.
?NXP B.V. 2013. All rights reserved.
Product data sheet
Rev. 7  25 February 2013
25 of 43
NXP Semiconductors
SA56004X
Digital temperature sensor with overtemperature alarms
8.2   Power sequencing considerations
8.2.1   Power supply slew rate
When powering-up the SA56004X, ensure that the slew rate of V
DD
 is less than 18 mV/ms.
A slew rate larger than this may cause power-on reset issues and yield unpredictable
results.
8.2.2   Application circuit
Figure 11
 shows a typical application circuit for the SA56004X, using a discrete sensor
transistor connected via a shielded, twisted-pair cable. The pull-ups on SCLK, SDATA,
and ALERT
 are required only if they are not already provided elsewhere in the system.
The SCLK and SDATA pins of the SA56004X can be interfaced directly to the SMBus of
an I/O controller, such as the Intel 820 chip set.
 
8.3   Timing and firmware consideration
It is important not to violate the conversion timing on this part.
Regardless of timing, the device could report an erroneous reading, but NXP, nor
reporting customers have not encountered two subsequent erroneous readings in its
product reviews or evaluations. Masking of single or two sequential erroneous readings is
recommended by comparing several reads should there be a large prompt change in the
temperature reading before taking protective action.
(1)  Typical value, placed close to temperature sensor.
Fig 11.   Typical application circuit
V
DD
SCLK
D+
SDATA
D
ALERT
T_CRIT
GND
SA56004X
2  2  1
1
2
3
4
6
5
8
7
shielded twisted pair
100 nF
2.2 nF
(1)
V
DD
V
DD
FAN CONTROL
CIRCUIT
+5 V
mote sensor
N3904 (NPN), 2N3906 (PNP),
r similar standalone, ASIC or
icroprocessor thermal diode
R
10 k?/DIV>
R
10 k?/DIV>
R
10 k?/DIV>
R
10 k?/DIV>
V
DD
CLOCK
DATA
INT
SMBus
CONTROLLER
相关PDF资料
SC2463TSTRT IC REG QD BCK/LINEAR 28TSSOP
SC338AIMSTRT IC REG CTRLR DUAL POS ADJ 10MSOP
SC402BMLTRT IC REG DL BCK/LINEAR SYNC 32MLPQ
SC403MLTRT IC REG DL BCK/LINEAR SYNC 32MLPQ
SC418ULTRT IC REG DL BUCK/LINEAR 20MLPQ
SC424MLTRT IC REG DL BUCK/LINEAR 28MLPQ
SC4250LISTRT IC HOT SWAP CTRLR 8-SOIC
SC427MLTRT IC REG DL BUCK/LINEAR 32MLPQ
相关代理商/技术参数
SA56004HDP 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:1 Degrees Celcious accurate, SMBus-compatible, 8-pin, remote/local digital temperature sensor with over temperature alarms
SA56004HDP,118 功能描述:板上安装温度传感器 I2C LOC +/- 2OC AND RoHS:否 制造商:Omron Electronics 输出类型:Digital 配置: 准确性:+/- 1.5 C, +/- 3 C 温度阈值: 数字输出 - 总线接口:2-Wire, I2C, SMBus 电源电压-最大:5.5 V 电源电压-最小:4.5 V 最大工作温度:+ 50 C 最小工作温度:0 C 关闭: 安装风格: 封装 / 箱体: 设备功能:Temperature and Humidity Sensor
SA56004HDP-T 功能描述:板上安装温度传感器 I2C LOC +/- 2OC AND REM +/- 1OC TS RoHS:否 制造商:Omron Electronics 输出类型:Digital 配置: 准确性:+/- 1.5 C, +/- 3 C 温度阈值: 数字输出 - 总线接口:2-Wire, I2C, SMBus 电源电压-最大:5.5 V 电源电压-最小:4.5 V 最大工作温度:+ 50 C 最小工作温度:0 C 关闭: 安装风格: 封装 / 箱体: 设备功能:Temperature and Humidity Sensor
SA56004HD-T 功能描述:板上安装温度传感器 I2C LOC +/- 2OC AND REM +/- 1OC TS RoHS:否 制造商:Omron Electronics 输出类型:Digital 配置: 准确性:+/- 1.5 C, +/- 3 C 温度阈值: 数字输出 - 总线接口:2-Wire, I2C, SMBus 电源电压-最大:5.5 V 电源电压-最小:4.5 V 最大工作温度:+ 50 C 最小工作温度:0 C 关闭: 安装风格: 封装 / 箱体: 设备功能:Temperature and Humidity Sensor
SA56004X 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:1 Degrees Celcious accurate, SMBus-compatible, 8-pin, remote/local digital temperature sensor with over temperature alarms
SA56004XD 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:1 Degrees Celcious accurate, SMBus-compatible, 8-pin, remote/local digital temperature sensor with over temperature alarms
SA56004XDP 制造商:PHILIPS 制造商全称:NXP Semiconductors 功能描述:1 Degrees Celcious accurate, SMBus-compatible, 8-pin, remote/local digital temperature sensor with over temperature alarms
SA560-SM 制造商:Panasonic Industrial Company 功能描述:SERVICE MANUAL